Welcome to Guilin HCM Machinery Official WebSite!

0773-3568321 mkt@hcmilling.com

Buy The Best Grinding Mill For Grinding Carbide Slag Powder


Release date: 2020-05-20 17:02:22

As industrial solid waste, what grinding mill machine can be used to grind carbide slag powder? According to the demand of industrial solid waste recycling, HCMilling(Guilin Hongcheng), a vertical roller mill manufacturer, recommends the adoption of a special vertical roller mill type selection and configuration scheme, which is conducive to turning carbide slag into a treasure, so as to obtain considerable profits and market value.

 

1. Introduction Of Carbide Slag 

 

Carbide slag is a large amount of industrial waste discharged in the production of acetylene by hydrolysis of carbide. As industrial waste, carbide slag not only occupies a lot of arable land, but also pollutes the environment seriously. Carbide slag is a high quality cement raw material with uniform composition and high calcium content. It is the most thorough method to produce cement by using it instead of limestone.

 

Calcium carbide slag can replace limestone to make cement, produce quicklime as raw material of calcium carbide, produce chemical products, produce building materials and be used for environmental control. In the production of cement with carbide slag, the technology of "wet grinding and dry burning" or pre drying "dry grinding and dry burning" is usually adopted.

 

Vertical mill is an exclusive equipment focusing on the industrial solid waste market, and it is also a successful mill developed by HCMilling(Guilin Hongcheng) in combination with this field.

 

2. Using Vertical Roller Mill To Increase Capacity Of Carbide Slag Powder

Vertical roller mill breaks through the bottleneck of low output, high energy consumption and high maintenance cost of ordinary mill. It has strong adaptability to high humidity, dry materials, hard to grind and easy to grind materials. It has a wide range of grinding fields and a very rich grinding type. It is a large-scale non-metallic ore pulverizing equipment.

 

It can be used for grinding coal, cement, slag, non-metallic ore, for high wet materials, dry materials, hard to grind materials, easy to grind materials, etc. It has wide applicability and wider grinding field.

 

The grinding mill equipment of HCMilling(Guilin Hongcheng): HLM vertical roller mill

[Capacity]5-700t/h

 

[Product fineness]22-180μm

 

[Application filed]It is widely used in electric power, metallurgy, cement, chemical industry, building materials, coating, papermaking, rubber, medicine, food and other production and living fields.

 

[Applicable material]: It has high-yield and high-efficiency grinding ability for all kinds of non-metallic mineral materials with Mohs hardness less than 7 and humidity less than 6%. For example, it has good grinding effect on cement raw material, clinker, power plant desulfurization limestone powder, slag micro powder, manganese ore, gypsum, coal, barite, calcite, bauxite, etc.

 

[Performance advantage]:It has the advantages of high grinding efficiency, low power consumption, large feeding particle size, easy adjustment of product fineness, simple equipment process, small floor area, low noise, small dust, low operation cost, and low consumption of wear-resistant materials.

 

Welcome to visit our factory at any time to know the details of the special equipment for vertical mill. The carbide slag vertical roller mill of HCM, which has high production and low consumption, environmental protection and noise reduction. Please call the hotline for more details.

Tel:+86-0773-3568321  

E-mail: mkt@hcmilling.com