The introduction to the process flow of superfine grinding machine

Ultrafine grinding mill is an ideal deep processing equipment, which is a professional grinding equipment made by Hongcheng through continuous improvement and innovation in combination with the production demand of fine powder market. The grinding machine has the comprehensive mechanical crushing performance of rolling, grinding, impact, etc. the fineness of the powder can be ground between 325-2500 mesh, and the customer can adjust the fineness of the finished product according to the demand.

The ultrafine grinding mill machine is suitable for grinding all kinds of non-metallic minerals with Mohs hardness less than 7 and humidity less than%, such as kaolin, marble, bauxite, bentonite, graphite, potassium feldspar, etc. It has large crushing ratio, high energy utilization rate, green environmental protection, high dust collection efficiency and high grinding efficiency. It is a professional mill that is conducive to improving the market competitiveness of enterprises.

The grinding machine is a typical mill which focuses on the production demand of the fine powder project. The mill has scientific technological process, high grinding efficiency, large capacity and fast efficiency improvement. It is a mill equipment to enhance the market competitiveness of enterprises and obtain market benefits.

Process flow introduction: it mainly includes four stages: crushing, grinding, grading and powder collection. In the crushing stage, the raw ore is crushed into material less than 10 mm by the crusher; then it enters the grinding stage, and the material is sent to the main machine cavity for grinding. Due to the rolling effect of the grinding roller, the material is continuously crushed and ground; now it is the grading stage, and the ground powder falls to the chassis due to the gravity effect In addition, it is blown to the classifier above the main machine for screening under the action of the air flow of the blower; in the powder collection stage, the qualified powder will be collected to become the finished product, and the unqualified powder will fall into the main machine again for regrinding.